4 major issues that need to be paid attention to about beautiful sewing! -Beautiful seam agent factory

Tile beautiful seam has become an important decoration project, so it is particularly important in the process of construction and acceptance. Whether you hire a professional construction team or plan to do your own DIY construction, you don't want to encounter troublesome things like rework, which will waste time and delay the construction period, and waste energy and money. In order to avoid rework, we must pay attention to details and be careful. Today, we will bring you common quality problems and solutions, so that you never have to worry about rework! 1. The color is lighter than the original, showing a white misty appearance. The cause of the problem: () The environmental humidity is too high. () Moisture is mixed in the construction surface, container, crevice, and beautifying agent. () The moisture contained in the bottom sealant has not been removed. () Use a poor beauty seam agent because it turns white due to transparency issues. Solution: () Dry treatment before construction. () Do not apply when the humidity is high. () The construction surface should be clean and free from moisture. () The bottom caulk or the water in the crevices of the tiles should be dried. () Choose good quality beauty seam products. 2. Due to poor adhesion and bonding, phenomena such as shedding, peeling, bulging, peeling, etc. will occur. Causes: () Poor quality of the caulking agent, resulting in poor adhesion between layers. The sealant used for the primer is too dry, or even in a powder state, and it has strong water absorption. If it encounters a thinner beautifying layer, it will often seriously affect the curing effect and cohesiveness of the beautifying agent. , So that the construction surface peels and falls off. () The crevices are dirty, stained with oil, water or other dirt. () Use inferior beauty joint agent () The construction temperature is too low. Solution: () Choose a good quality sealant for primer. () The oil, moisture or other dirt should be thoroughly removed when the substrate surface is treated. () Choose high-quality beauty seam agent, Shangsil real porcelain has strong bonding force, does not fall off, and does not collapse! 3. After a period of time, it is still not dry and does not harden. Reason: () A/B two components are not evenly mixed. () Throw away the materials that have not been punched out by centimeters during construction. When a new material is first used to hit the two tubes A and B with a glue gun, one side will always come out first. At this time, the material is not evenly mixed (that is, there is no: mixing). If the waste material of this centimeter is not thrown away, it will be hit Cause the product to not cure. () When workers are filling, air will occasionally enter the hose, causing the capacity ratio of the AB group to be out of balance. In this case, intermittent non-curing or partial non-curing will also occur. () After the centimeter of the material is shot out and thrown away, if the opening of the mixing tube is too small, it will also cause the ejected material to be in an unmixed state after the centimeter is thrown away. Solution: () Construct according to correct construction requirements. () The opening of the mixing tube is opened as required. () One mixing tube is equipped with one beautiful seam agent. Fourth, the cause of the problem of air bubbles: () During filling or transportation, air enters inside but is not discharged, and the glue cannot be mixed according to the ratio of:, resulting in non-drying (unscrew the glue nozzle, pier a few times on the ground, push the piston at the bottom of the bottle, Screw on the glue nozzle and carry out construction) () The gap is not cleaned, the environment is humid, and the material enters the air during transportation (filling is vacuum filling, and transportation is violent transportation)! Solution: () Do it back and forth several times where there are bubbles. () Holes are punched at both ends of the tile gap, and when pressing the seam, press to the empty position (usually punch in the direction of the lower end)
Beauty Sewing Question Attention