Archaize brick seam Angle of flower beauty step ( Note)

Archaize brick is usually refers to the glaze decoration brick, the body can be porcelain stoneware, standard and the standard quality; Glaze is given priority to with inferior smooth; Tone with yellow, brown, dark red, soil color, gray, a film; Evolved from CaiYouZhuan, actual archaize brick is glaze of porcelain tiles.

seam Angle of archaize brick flower beauty step

because archaize brick surface rough uneven, if use oily true porcelain beauty to make archaize brick seam, a process with more than other ceramic tile & ndash; — Crepe paper. As crepe paper, it will be more than is expected to remain on the ceramic tile. If it is to use the new water-based environmental protection beautiful seam an agent, then, is completely different construction methods, construction method is more simple and convenient, abandoned completely, crepe paper directly use water to clean type.

if the Angle of flower type of archaize brick, edge horn is very irregular, at this point either with true porcelain porcelain or water, is inevitable to stick textured paper, avoid excess stock to spend. Angle of flower is the adornment design, some Angle is uneven, water can be porcelain while water wipe, but if get into decorative pattern, all want to clean up is not easy.

seam Angle of archaize brick flower beauty step

1, guarantee the construction base must be smooth, solid, no dust.

2, ceramic tile seam width is best.

3, discharging mouth mouth, discharging to uniform.

4, each finished once again pointing out of the mouth since the spill a small amount of material available paper erasure.

5, in the cross interface more small brick construction should be in line with less as far as possible the material, material is not out of the seam, completed the horizontal seam in the process of scraping in cross joints shall blow gently to prevent material.

6, after construction must wait until the surface is slightly dry again after the seam an agent to remove spilled material

7, if it is sponge brush type method, to wipe down the gap on either side of the, if began to excess stock is too much, can use first part scraping an eraser to reoccupy sponge.

8, 12 hours after the ground construction, before the material did not work, don't walk on it, so as not to get dirty on the ground, the seam an agent surface dirt pollution.