Because the seam an agent and dry, and how to avoid the seam an agent, and the solution seam an agent do

Content abstract: the reason seam an agent and dry, and how to avoid the seam an agent, and the seam an agent not solution. Beautiful seam an agent is not the cause of the curing, also is the reason why the seam an agent not stem: beauty seam an agent is a two-component, AB components, AB component in the mixed rubber mouth mixing after curing, similar to the AB glue, like nail polish, did not mix well, of course, not curing, AB components each glue adhesive time grow out of the barrel is different also.

the reason seam an agent and dry, and how to avoid the seam an agent, and the seam an agent not solution.

the seam an agent is not the cause of the curing, also is the reason why the seam an agent not stem: beauty seam an agent is A two-component, components of AB, AB component in the mixed rubber mouth mixing after curing, similar to the AB glue, like nail polish, did not mix well, of course, not curing, AB various plastic tube inside the plastic components of time is different also, the key is manufacturer at the time of canned glue AB component does not guarantee completely inside the same amount, so when the beautiful seam an agent into the glue guns glue, the glue is not consistent, if A or B first mixed into the mouth, will be mixed in front of the mouth has A comparison of A single, either A or B, so don't cure. Another reason is AB there is air cylinder inside, have the air, at some time in glue mixed into the mouth of A B is A glue or glue is another air, this is, of course, not curing, the seam an agent just quit.

the seam an agent solution: instead of curing and dry after obtaining a beautiful seam an agent, the first step is to unscrew the lid, then press it in glue guns started above ground put a cardboard or can catch plastic containers, abandoned in the extrusion to glue into the trash can, observe the AB glue tube two discharging mouth after the glue at the same time, combined with mixed cement, pay attention to safety, don't put the adhesive to the hand or other objects, not easy to erase. On mixed mouth after, at that time can make gum, edging out at most 3 cm is enough, then glue can solidify, wouldn't quit. If colloid there are air, this is the product without pumping air into vacuum state, it is looking for manufacturer to exchange products.

ok, above is my beautiful seam an agent construction experience 10 years, want to see this article, some praise, leave a message. Thank you for your support! Forward

absolutely original, reproduced please indicate from the seam an agent, clearly in the website: http://www. oliyun。 com/