Beijing dry powder spike anchoring agent manufacturer: how much is one ton

Powder spike anchoring agent production factory introduction: huaxia caulking agent factory company introduction concrete sleeper railway, bridge pillow spike, mostly using sulfur by anchor spike agent. Anchoring spike to boil of sulfur, sulfur, the environmental pollution caused by the construction also had trouble; Concrete local thermal cracks may be produced, reduce the service life of the spike. TD type spike anchoring agent is a new type of high-strength anchorage from inorganic mixture material, it has rapid hardening, high strength, micro expansion, cold operation construction, etc. Save the heating process, in particular, on the environment pollution-free, avoid the site construction of fire hazards. Sleeper spike anchorage, after 2 million times of fatigue test result is good. Beijing dry powder spike anchoring agent manufacturer: price reference price: how much is a ton of spike anchoring agent? A: spike anchoring agent price 3500 yuan per ton type classification: 1, the railway spike anchoring agent 2, dry spike anchoring agent 3, environment-friendly spike anchoring agent dedicated railway sleeper anchoring agent screw spike anchoring agent main use: 1, the pillow is suitable for railway concrete sleeper, bridge the spike of anchorage, prefabricated Bridges cemented joints, mechanical equipment of the anchor bolt anchorage. 2, is suitable for the railways, tunnels, water diversion tunnels, coal mines, pier reinforcement, building aseismic, metallurgy, mining and other underground engineering with anchor rod for supporting the rapid construction of surrounding rock, and hold nail anchor in concrete structure reinforcement engineering, and can meet the requirements of steel welding. Use scope: concrete sleeper railway, bridge pillow spike anchorage; Prefabricated Bridges of cementing joint anchorage; Mechanical equipment of anchor bolt anchorage; Usage: construction method of use hold nail anchor in concrete structure reinforcement engineering. Beijing dry powder spike anchoring agent manufacturer: price remove debris, dust and pollutants in hole. In anchorage with a cork, clay and so on in the bottom of the bore wall, prevent leak slurry. Spike of anchoring depth shall not be less than 150 mm. Remove the rust on the surface of the spike, grease. Anchoring agent will pour into the pot, stir said anchoring agent 13 to 14% of the weight of water, mix with anchoring agent 2 ~ 3 minutes. Anchoring agent, mixing evenly on perfusion into the spike to leave a hole with tamping tamping. Will spike from upper rotating pressure of grouting hole into the hole in the middle of filling of anchoring agent, set into the spike positioning plate, with another spike tapping the cat's head, the vibration close-grained anchoring agent. When the anchoring agent hardening > 35 mpa compressive strength, can force. Note: spike anchoring agent can be used under the condition of low temperature and negative temperature, but due to the low temperature, curing time longer. When used on insulated to demand higher line, need to be approved by relevant departments. Recommend the use of insulating casing or insulated daub on the spike. Spike anchoring agent should prevent be affected with damp be affected with damp, be affected with damp be affected with damp anchoring agent shall not be used. It will be valid for one year. Performance of the above pictures for spike anchoring agent, and the standards! Below as the spike anchoring agent construction technology