Carbon fiber sheet (CFS) method and maintenance

Carbon fiber sheet (CFS) method and maintenance 1. Pasting carbon fiber sheet (CFS) according to the size of the design requirements of cutting carbon fiber cloth, unless special requirements, carbon fiber cloth length should be within 3 m. Preparation, mixing Jacqueline Nottingham - C3P paste adhesive material, and then in the paste evenly with roller brush, more appropriate in lap, corner place daub some. Carbon fiber sheet (CFS) along the stress direction of the lap length should be less than 100 mm, the layers of overlapping position should be staggered. With smooth roller rolling repeatedly in the surface of carbon fiber cloth in the direction to leak rubber on external surface of the carbon fiber cloth, to remove bubbles and make fully infiltrates rubber carbon fiber cloth. Multilayer paste should repeat the above steps, refers to the fiber surface touch dry advisable, can on to the next layer of carbon fiber cloth paste. In the most outer layer of the outer surface of the carbon fiber cloth evenly daub a layer of paste adhesive materials. 2. After the carbon fiber cloth reinforcing maintenance within 24 hours after the completion of construction to prevent rain or be affected with damp be affected with damp, and pay attention to protect, prevent hard construction surface bruised. 约- C the curing temperature shall not be lower than 5 ℃. Average temperature is 20 ~ 25 ℃, the curing time shall not be less than 3 - 7 days; Average temperature of 10 ℃, the curing time shall not be less than 7 10 days.