Ceramic tile is not can do the seam sewing

Floor tile shop sticks are of seam is normal, is only the width of the seam is not the same as the size, this is also the basic common sense. But hard to avoid some people are against the basic common sense, the pursuit of the so-called & quot; Seamless brick & quot; For floor tile shop is stuck, can't have crack, even a little gap, but not more than 1 there is no doubt that this is wrong.

floor tile not seam, expansion joint?

if when decorating a floor tile shop is stuck not intended to do the seam, so only when the shop is stuck set aside 1 mm gap, but wait to decorate fast completion after seeing someone's home ground to make the seam is very beautiful, at that time his home can also like to do on the floor tile expansion joints seam. Floor tile shop is stuck not seam, after the completion of the late through the use of equipment to expansion joint, here to tell you the standard answer is impossible to reality!

have this idea may be via a channel to see someone gets a small cutting machine like in expansion joint, although was seen, but that's not to crack in the floor tile of expansion joint but clean floor tile cement, belongs to the seam crack-cleaning before construction link, don't be wrong.

so floor tile shop is stuck is gap less than 1 mm, even smaller, almost no gap, as in this case, the cut need not use forced second slot expansion joint, it is bound to be bad cutting ceramic tile, do more harm than good.

floor tile aperture is small, also want to do the seam, how to do?

if floor tile shop is stuck already finished, also realized that the so-called seamless actually still have crack, want floor tile cracks easier to clean, also the same dirty and faded, so this kind of circumstance can choose beautiful seam caulking and two ways.

the joints floor tile gap less than 1 mm, in this case if you want to do is beauty, the beauty of the traditional construction joints with glue gun, glue directly construction method is not possible. You can according to the steps below to proceed with construction joints in the United States:

1. First floor tile crack-cleaning processing. Can sew professional cleaning tool, if you feel the manual operation crack-cleaning is laborious and time-consuming, so we can choose the electric, fitted with a special needle or soot cleaning blade. But when it is important to note that, prevent cut ceramic tile;

2. Gap after the impurities were clearly, the vacuum gap within the impurities are clean, absorption edge position of vacuum cleaner can't to use brush to clean;

3. Will be beautiful seam an agent into the wood, stir well, with art design knife into the gap,

4. Then the secondary pressure seam, on the edge of the ceramic tile aperture will have residual beautiful seam an agent, and so on the seam an agent dry reoccupy after the blade to scrape off the excess glue can.

caulking

1. Quality pass caulking agent. Floor tile without gap is too small do not consider the seam, so you can use the traditional caulking to do, now in the market with quality pass the gap filling agent, can do not fade, not moldy.

2. Epoxy fill color sand seam an agent. Use of more advanced epoxy color sand filled seam an agent to do, so also can guarantee the floor tile gap never fades, no mold, at the same time to bear or endure dirty, and after the effect is very beautiful.