Ceramic tile seam an agent before construction matters needing attention

Note 1 before beauty ceramic tile seam an agent construction. Floor construction environment just good ceramic tile is cannot be beautiful stitch, then at least a week to dry, mortar solidification, ceramic tile and aperture are dry, and then to the seam. Low winter temperatures, may want to postpone drying time. Note: the longer the drying time, the effect of construction joints, the better. Domestic outfit dust is bigger, so ceramic tile aperture after cleaning, should be with a vacuum cleaner filter it again, and then use of ceramic tile and aperture half-dry towel to wipe it again. 2. The environment temperature beauty ideal construction temperature is 10 - seam an agent 40 degrees, the temperature is too low will lead to colloid thicken, suggest using heating blanket or 80 degrees hot water heating. 3. The construction method of different ceramic tile, different products, construction methods are not the same. So understanding the performance of ceramic tile, understand the different products, according to ceramic tile to confirm the sewing products and specific methods, and then started the construction. Method, if used the wrong product, it is will greatly influence the effect of the seam. Note: archaize brick, prevent slippery brick, marble, rough surface can wax, need sticker 4 grooves are deep. Material preparation method determines the ceramic tile, is ready to construction materials. Measure good construction area ( Contain the width and depth) of aperture , confirm the quantity of materials required. According to the construction method, ready to the tools. Is not only to foot, construction of the controls. 5. Remaining material cleaning is affected by environment, spring, summer, 4 hours, 4 - autumn and winter More than 8 hours can wipe out the material.