Professional manufacturer of tile grout and adhesives with 27 years experience

Ceramic tile seam beauty how construction ( Seven process to create a good gap)

2020-12-04

Kastar

120

In the installation of floor tile, in order to more beautiful, the gap between the floor tile and floor tile, we will try to solve, at this time, you can consider the seam an agent, beauty of ceramic tile seam an agent is in at the moment. So, how to operate the seam an agent, in construction above we can how?

how beauty ceramic tile seam construction to prepare ceramic tile seam to the tools used in the United States: glue guns, brush, sponge, paper, scraper, pen knife, nozzle, the seam an agent

1, the first step is to clean up the brick seam, after the first transverse vertical, dug 0 with box cutters. Until 8 mm groove, groove on both sides of the ceramic tile edge, again with dry cloth or brush clean up the dirt of crevice, if there is dust, seam an agent is not to be especially careful crossing intersections.

2, in the gap on both sides of 0. About 5 mm stick good (crepe paper PS: stick too close to tear the crepe paper is easier to take the beauty of a crevice seam an agent; Stick too far left in the beauty of ceramic tile seam an agent is much, easy to waste. ）

3, will the seam an agent installed on the glue guns

4, hold down the glue guns and play beautiful seam an agent, Glue guns and ground 45 & deg; As far as possible, uniform) , don't be too long, because the seam an agent is easy to dry, dry wipe the is bad.

5, the beautiful seam an agent with scraper scraping (evenly Scraping when a child is tilted) , attention must be flat, if not leveling, still have the groove, even if the gap with the seam an agent, groove, or dust.

6, use a sponge, clean up the beauty of excess seam an agent, fast, seam an agent in the United States didn't dries quickly wipe up, can not wipe off what he had done.

7、. Tear, crepe paper accomplished

to decorate their own, ceramic tile graphic, feel the seam construction is very simple, if you think so is wrong, the seam an agent is a delicate work, mushroom ye say below is big, ready to these considerations, to make ceramic tile aperture.

the ceramic tile seam note

1, in the process of doing the seam an agent, brick seam is freely crisscross, when doing the seam, to one direction all the cracks on the finish first, wait for dry after appearing to another direction on the aperture, otherwise when cross jointing, feet will carelessly trampled GouHaoDe seam first, for the joint of the first set is not dry, trampled and then will be very ugly, and the cross intersections of aperture is very bad.

2, had better close the window when do the seam.

3, empty drum can't use the seam an agent. Because empty drum ceramic tile deformation will happen on the above, is beyond the scope of the seam an agent is a pull, a long beautiful seam an agent empty place will fall off.

4, the United States is quick-drying type seam an agent, a construction up to 1250 px on the seam an agent with a wet sponge in addition to overflow the beauty of the seam an agent, or it will touch don't come down on the edge of the ceramic tile, and even hang up there will be a small amount of residual, people with their feet trample will turn black, not only did not achieve the result of the seam an agent, only will be worse than the original.