Professional manufacturer of tile grout and adhesives with 27 years experience

Ceramic tile seam filling agent construction steps ( This is true)

2020-08-01

Kastar

146

Ceramic tile are used nowadays most people home filled seam an Kastar grout, it can make up for the deficiency of ceramic tile, ceramic tile with beautification effect, but also solves the owner for ceramic tile seam mildew, black. , then, to share professional and right below the ceramic tile of caulking Kastar grout construction procedure, and ceramic tile caulking should pay attention to?

ceramic tile gap filling construction method right

brick seam cleaning

before using caulking agent need to sew the ceramic tile with the awl in the clean up dirt, brush with wool and then Saul again, until the ceramic tile seam no dirty material, ceramic tile seam on both sides of the towel to clean dust, grease and other pollutants.

the hem on crepe paper

with the notes then paper along the two ceramic tile seam line well, be careful not to stick a crooked, preferably along the ceramic tile aperture is about 0. 5 mm distance, and guarantee the position of the gaps in the middle to keep good, in order to guarantee the effect of cross intersections, somehow the line construction Suggestions separated for 24 hours a day. On either side of the crepe paper will cut neatly without burrs, width is not less than 2 cm, stick relay is better but not residual glue.

rob dozens to sew

choose good caulking glue, set up the special mixing tube, the mixing of caulking Kastar grout nozzle are generally not arrow, suggest oblique cut with the knife, mouth wants moderate, not too big nor too small, it is better than small ceramic tile aperture, such easy to operation. And then put on special high quality energy glue gun, 30 g caulking glue, squeeze to remove the front makes the mixture caulking glue fully. Mixing tube as possible at the seam vertical to true porcelain and ceramic tile surface glue fills gaps, while walking even, good grasp of the intensity and frequency so that the true porcelain out the glue. 5 - appropriate temperature 38 degrees.

seam pressure iron

if you want to make true porcelain adhesive cured surface has a moderate arc surface, can use special pressure seam steel ball from brick force along the seam at one end to the other side, hard to maintain uniform, If you want true porcelain and ceramic tile adhesive cured performance surface as far as possible in a horizontal plane, can use the caulking scraper or soft rubber sheet from brick force along the seam at one end to the other end, maintain strength, and do not deviate from the crepe paper to prevent pollution of ceramic tile surface. Be cleaned

if use technology of crepe paper, let stand for 5 - 10 minutes. Tear the paper to remove the surrounding true porcelain gel filled seam an agent, wipe the stains. If use of technology of crepe paper, will have to wait until after seam about 3 hours, with a special clean shovel will be half solidification of true porcelain glue on the surface of the ceramic tile is clean.

ceramic tile caulking should pay attention to what the

1, the need to clean up the dirt on the surface of the ceramic tile and aperture, clean before caulking gun construction.

2, mouth to mouth at a 45 degree Angle, material width than small ceramic tile aperture, because ceramic tile aperture is different, so according to the situation to decide.

3, the caulking agents at the bottom of the TAB, and then put the caulking agent into glue guns, evenly into ceramic tile aperture.

4, caulking gun when the strength should be uniform, wet sponge to wipe also take special care.

5, the construction after the completion of the surface already cured after two hours, two days later can normal use.

6, caulking agent should aim to the straight line can lateral play first, and then vertically.