Does the tile adhesive appear 'shrinkage' phenomenon? Don't be afraid, I will teach you a perfect solution-Mei Suture Factory

When decorating and tiling tiles in our home, we always encounter various situations. When tiling tiles, some owners will buy some tile adhesives to improve the adhesion between the brick body and the wall. But because of lack of experience, you will always encounter some problems, such as the most common 'shrinkage'. What causes this? Let’s take a look at what is shrinkage. 'Shrinkage' means that after the tile adhesive is applied, the wet emulsion quickly migrates to some unspecified positions, resulting in blank positions of different sizes. In better cases, only a few areas appear blank, and in serious cases, more than half of the positions appear blank, and finally a complete coating film cannot be formed at all. Reasons for the formation: It may be because the owners are greedy for cheap when buying tile adhesives and bought inferior products. Therefore, even if there are even the best construction masters on the sidelines, the phenomenon of 'shrinkage' will occur. Solution: When buying high-quality tile adhesives, when you buy tile adhesives, you must look for ceramic tile adhesives that meet the relevant national standards. In addition to helping double-sided pasting, the adhesive also has a certain degree of water resistance. The company’s strong ceramic tile adhesive (special for large slabs with great value), a trusted professional brand, uses the principle of chemical bonding, and is optimized by polymer modification. The products are strictly in accordance with the ceramic tile adhesive (JC/T -) The new version of the industry standard is implemented, safe and environmentally friendly, non-toxic and harmless, with obvious back stickiness, and no whitening when soaked in water. , Another reason for 'shrinkage' when the base surface is not cleaned up may be because of the oily film attached to the base surface! The reasons for this phenomenon may be: ① The base surface is contaminated by external oil during production, processing, transportation and storage, such as diesel, asphalt and even edible oil. ② Water-based wax, which is used for temporary protection of the front of the tile, stains the back of the tile due to improper processing. ③ When the ceramic tile is produced, the back will contain a large amount of release agent, which can be added to facilitate the removal of the tile from the mold. If these release agents are not cleaned during use, they will be to a certain extent. The upper prevents the adhesive force between the adhesive and the tile. There will be no shrinkage on the back of the tile. How to deal with the shrinkage phenomenon can be wiped with alkaline powder containing cement, such as dry cement powder, dry joint filler powder or dry tile adhesive powder, and then rinse with water. Here are some common questions about the use of tile adhesive: Can the tile adhesive be directly painted on the wall? Can't! Because the adhesive is used to strengthen the back primer when all kinds of high-quality tiles are pasted, it cannot penetrate and reinforce the wall. Can the tile adhesive be directly added to the tile adhesive? Can't! This will not only affect the precise ratio of the tile adhesive, but also greatly reduce the bonding strength of the tile adhesive. Can the tile adhesive be added water to paint the wall? Can't! Adding water to the adhesive will not only dilute its original polymer content, seriously affect the quality of the product, but also cause problems such as polycondensation and sagging during construction. Buy tile adhesive, look for the US joint agent factory
Tile adhesive shrinkage