Frequently Asked Questions and Treatment Methods of Real Porcelain Adhesive Glue

In order to avoid rework, we must pay attention to details and be careful. Today, we will bring you common quality problems and solutions, so you never have to worry about rework! 1. The color is paler than the original, showing a white misty appearance. The cause of the problem: () The environmental humidity is too high. () Moisture is mixed in the construction surface, container, crevice, and beautifying agent. () The water contained in the bottom sealant has not been removed. () Use a poor beauty seam agent because it turns white due to transparency problems. Solution: () Dry treatment before construction. () Do not apply when the humidity is high. () The construction surface should be clean and free from moisture. () The bottom caulking agent or the water in the gap of the tiles should be dried. () Choose good quality beauty seam products. 2. Due to poor adhesion and bonding, phenomena such as shedding, peeling, bulging, and peeling will occur. The cause of the problem: () The sealant is inferior, resulting in poor adhesion between layers. The sealant used for the primer is too dry, or even in a powder state, and it has strong water absorption. If it encounters a thinner beautifying layer, it will often seriously affect the curing effect and cohesiveness of the beautifying agent. , So that the construction surface peels and falls off. () The crevices are dirty, stained with oil, water or other dirt. () Use inferior beauty joint agent () The construction temperature is too low. Solution: () Choose a good quality sealant for primer. () When treating the surface of the substrate, the oil, moisture or other dirt should be completely removed. () Choose high-quality beautifying agent, the crystal porcelain king of the beautifying agent factory is strong, does not fall off, and does not collapse! 3. After a period of time, it is still not dry and does not solidify. Reason: () A/B two components are not uniformly mixed. () Throw away the materials that are not hitting about a centimeter at the front end during construction. When a new material is first used to hit the two tubes A and B with a glue gun, one side will always come out first. At this time, the material is not uniformly mixed (that is, there is no: mixing). If the waste material of this centimeter is not thrown away, it will be hit in the seam Cause the product to not cure. () When workers are filling, air will occasionally enter the hose, causing the capacity ratio of the AB group to be out of balance. In this case, intermittent non-curing or partial non-curing will also occur. () After the centimeter of the material is shot out and thrown away, if the opening of the mixing tube is too small, it will also cause the ejected material to be in an unmixed state after the centimeter is thrown away. Solution: () Construct according to correct construction requirements. () The opening of the mixing tube is opened as required. () One mixing tube is equipped with one beautiful seam agent. Fourth, the cause of the problem of air bubbles: () During filling or transportation, air enters inside but is not discharged, and the glue cannot be adjusted according to the ratio of:, resulting in non-drying (unscrew the bottle cap, pierce the ground a few times, push the piston at the bottom of the bottle , Screw on the mixing rod, and carry out construction) () The gap is not cleaned, the environment is humid, and the material enters the air during transportation (filling is vacuum filling, and transportation is violent transportation)! Solution: () Do a few times in the place where there are bubbles. () Punch holes at both ends of the tile gap, and press to the empty position when pressing the gap (usually punch holes in the direction of the lower end).
Beauty Seam Agent Real Porcelain Adhesive Problem Solution