Ceramic tile is filled seam an agent, high-strength non-shrinkage ceramic tile is filled seam an agent, CGM ceramic tile seam filling grout construction at the site, the equipment foundation by grouting, anchor bolt is fixed, small project operation, the objective conditions constraints such as the construction progress is slow, can use electric hand drill used as a stirrer. Have many common problems in fuzhou, capital of ceramic tile gap filling grout factory zhengde building materials for detailed analysis. This case mix difficulties there are three reasons, first: the power of electric hand drill is insufficient, to replace the smaller the diameter of the stirrer bar, the diameter of the steel to reduce, use the power of the blender is not less than 700 w power, and had better choose low speed mixer for mixing. Second: water content is low, in general, is in accordance with the powder of 12% To add 15% of the water, the powder is too much, too little water, under the condition of low water cement ratio, mixing arduous problems will occur. Third: packing bag with paper-plastic composite triad, combined the packing bag of products in two ways, the inside of the bag plastic film bag is easy to fall into the mix material container, mixing materials barrels, at that time, the plastic film bag wrapped to blender mixing rod, added to the resistance. Also, the packet is there are a lot of fine lines and plastic braided line will be easy to fall into, also can appear the same problem. When mixing, must first into powder and then adding water in the mixing container, in order to avoid mixing unevenly, the chemical materials inadequate mixing dry mortar, effect use effect and let stand for 2 - 3 min time to use, the effect will be better. When need to add the standard water consumption, according to the manufacturer's certificate the water added fill out the above indexes, use according to weigh out the standard of each lump powder used in the water, into the container, to scale recorded in the corresponding position in the container, according to the proportion of standard to stir, to look into the slurry after texture, ensure quality of mixing. If after adding water, think too much water, not allowed to pour out water with some powder material, this will affect the performance of the material, should add powder after continue stirring. Above is the fuzhou zhengde building materials to ceramic tile gap filling agent manufacturer summarizes common problems of ceramic tile gap filling agent construction, hope I can help to you, have a need to know more friends can enter our website or call advisory!
To be the best worldwide provider of higher-value tile grout and the center for quality employment opportunities.
Kastar Adhesive Co.,Ltd. also maintains a friendly, fair, and creative work environment, which respects diversity, new ideas, and hard work.
There's the area of manufacturing tile grout that's becoming very important. If you can create those things, you build this closed bond.
Contact Us
Better Touch Better Business
Contact Sales at Kastar.
Call Us
+86 13924533378