High-strength non-shrink grout material mixing with how much water?

Many clients in the purchase of high-strength non-shrinkage grouting material, construction, water is expected to master than does not reach the designated position, lead to engineering problems, high-strength non-shrink grout material mixing and exactly how much water would be good for caulking agent manufacturers building materials below small make up with everyone learning together: high-strength non-shrinkage grouting material construction of mixing water is critical in this step, it is the key to decide whether grouting material dense. If grouting material at the time of the mixing, mixed with gas or water, will cause the grouting material construction can appear sometimes the phenomenon such as cracks, subsidence. High-strength non-shrink grout material mixing at the time of the matters needing attention are as follows: 1, using material barrel stirring, strictly in accordance with relevant provisions of the certificate on the recommended water consumption. Every time a bag ( 50 kg pack) Water consumption is 6, regulations. 5 kg, that is, water cement ratio is 13%. Under the condition of meet the requirements of fluidity, water consumption can be in 6 - 6. 5 kg range change. （ The concrete is provided in the certificate of approval shall prevail) 2, the first to pour into the prescribed dosage of water in the bucket, then about half ( 25公斤) Stir in barrels, about 10 s, then in the remaining half of material mixing together. Secondary stirring time should be controlled within the 60 s. 3, the grouting material hand electric drill with homemade blade used for mixing. Mixing, blade should move slowly up and down the barrel of surrounding, and stirring blades up may not be up to above the liquid level, prevent into the air.