High-strength non-shrinkage ceramic tile gap filling agent construction process

Fujian high-strength non-shrinkage ceramic tile is filled seam an agent is a kind of performance can be adjusted the ultra high strength and large flow of materials. With fast setting time and good flow property, high early strength, fatigue resistance performance is good, not afraid of cold summer, convenient construction, etc. Can be widely used in repair and construction of special requirements such as high strength. Below for the high-strength non-shrinkage ceramic tile gap filling agent construction process: 1, the water content: according to each bag ( 25公斤) 4 with water. 0 ~ 4. 5 kg water mixing proportion, such as the construction does not need large fluidity can reduce water consumption accordingly. 2, mixing procedures: in the mixing barrel to join after the specified amount of water into blender, will be part of a slurry stirring dilute inside bucket, then into the mix, time should be controlled from start to finish in a minute or so. 3, mixing, blade should be to move slowly from side to side, up and down on the barrels around so that the bottom and the barrel wall adhesion to the mixing of dry material; Mixing blade shall not to a pulp level, so as to avoid air into a pulp. 4, HGM track cement mixture should be watered in time. Water, as far as possible from the side of the injection in order to discharge the air between the base plate and concrete foundation. When necessary, can use the tools such as bamboo diversion. At the start of the water must be continuous, not continuous.