Introduction of KASTAR MS Polymer Sealant Factory
How much do you know about the construction process of the beauty joint
by：Kastar
2021-04-06
When decorating the floor of a new house, many people will do beautiful stitching after finishing the floor tiles. Not only can the service life of the tiles be enhanced, but the increased indoor effect is also very good. But for the construction process of the beauty joint agent, have you ever found out about it. Today, the editor will introduce to you the construction process of the US joint agent?
In the first step, we have to prepare the tools we need, and we need to use the beauty joint agent, a knife, a glue gun, and a rag.
The second step is to put the beauty joint agent into the glue gun. One thing to note here is that the discharge port of the glue gun we choose should be about the same size as the tile gap, so that the construction can be better.
The third step is to aim the glue muzzle at the gap of the tile, and drive the beauty agent into the gap. You know, the beauty joint agent is easier to dry out, so every time you hit about 1m, and then you need to clean the surrounding beauty joint agent with a knife, so as to better ensure that the tiles will not be damaged.
The fourth step, the amount of beautifying agent needs to be considered according to different tiles: if it is a slope angle brick, the amount of beautifying agent should not be too much to avoid leakage; if it is a small piece For mosaic tiles, the amount of beautifying agent injected should be small and well controlled; for right-angle tiles, the beautifying agent used should be increased appropriately.
The fifth step, after the completion of the construction, you need to check the entire ground. If there is a beauty joint agent around the gap, it should be disposed of in time to avoid affecting the overall aesthetic effect.
In the first step, we have to prepare the tools we need, and we need to use the beauty joint agent, a knife, a glue gun, and a rag.
The second step is to put the beauty joint agent into the glue gun. One thing to note here is that the discharge port of the glue gun we choose should be about the same size as the tile gap, so that the construction can be better.
The third step is to aim the glue muzzle at the gap of the tile, and drive the beauty agent into the gap. You know, the beauty joint agent is easier to dry out, so every time you hit about 1m, and then you need to clean the surrounding beauty joint agent with a knife, so as to better ensure that the tiles will not be damaged.
The fourth step, the amount of beautifying agent needs to be considered according to different tiles: if it is a slope angle brick, the amount of beautifying agent should not be too much to avoid leakage; if it is a small piece For mosaic tiles, the amount of beautifying agent injected should be small and well controlled; for right-angle tiles, the beautifying agent used should be increased appropriately.
The fifth step, after the completion of the construction, you need to check the entire ground. If there is a beauty joint agent around the gap, it should be disposed of in time to avoid affecting the overall aesthetic effect.
Custom message
Related Products
