How to do it is the correct position of water porcelain construction

Zocoo seam water porcelain beauty for a two-component water-borne epoxy resin type of green environmental protection products. Water porcelain beauty seam is colorful, simple sense is good, has the alkali resistance, crack resistance, wear-resisting, be able to bear or endure corrupt, durable, outstanding characteristics such as chemical corrosion resistance, easy to clean. But sometimes, also can appear crack, fall off, is this why? We analysis for the following reasons: 1 crack-cleaning process operation is unqualified, then, how to operate is right? 1. First of all, should be taken before the construction will be the dust with a vacuum cleaner to suck in the ceramic tile aperture clean. 2. Use a wet towel to wipe clean on both sides of ceramic tile aperture, removal of dust, grease and other contaminants. At the same time, with clean shovel to remove contaminants on the surface of the ceramic tile, finally, again with a dry towel dry on both sides of ceramic tile aperture. In this way, our ceramic tile aperture is clean. 2 water porcelain porcelain construction after the loss of water and the biggest difference between true porcelain, is the environmental protection and water soluble, and it is for this reason that cause water compared with true porcelain porcelain, the strong consistency of some lower its viscosity and materials. So, to ensure high cleanliness of ceramic tile aperture, is to ensure that water porcelain after construction from off the inevitable. Porcelain surface cleanliness requirements of the construction process and the water is higher, because the surface tension of the water, sewage water porcelain causes shrinkage cavity, cause water porcelain are difficult to fit on the ceramic tile aperture. Of ceramic tile aperture as much as possible before the construction of clean and keep clean, make ceramic tile aperture is dry, excluding oil, dust, water, etc. , so that water porcelain and ceramic tile aperture to perfect fit. Can effectively prevent the loss. 3 water cracks on porcelain after construction situation like this, after water porcelain in the improper construction, not only will appear fall off, also can appear here, we are told by crack. How to avoid? Please see here. 。 。 Because the water porcelain with water-soluble, relative to the true porcelain to dilute some, leading to a material, water pressure needed for the porcelain is relatively lower than true porcelain. Therefore, we should pay attention to the construction, to control the intensity and frequency, let water porcelain material in ceramic tile aperture, bao hou uniform level consistent, so that it can effectively avoid water crack of porcelain. Well, today's share is like that. This article copyright WWW. zhuogao。 All. net, reprint please indicate the source or contact small make up, offenders