How to make the construction seam an agent? （ The method is very simple! ）

Now a lot of people want to do the seam, but expensive construction cost a lot of people, the seam actually can do it yourself, the construction method is simple, mainly divided into crack-cleaning, glue, seam pressure, plastic shovel the four steps, but before that, we need to take a look at, these steps should be how to operate it.

the sew one of the most important steps, and the first step is to clear seam, gap should be removed first, behind such steps can run smoothly. Step by step, and then in sequence to the seam well, look at these steps are how to operate.

a gap

and cleaning a gap is has the certain difficulty, if you have implants inside, can use the crack-cleaning cone, reoccupy cleaner brush or out dust. But if inside filled in the cement, need to ask professional personage to clean up, so as to avoid broken tiles. Crack-cleaning gap on both sides must clean up, and to set aside more than 1 mm width, the depth of about 3 mm. Gap to keep dry, as a result, gap is clear.

2, glue

the beautiful seam an agent is installed on the glue guns, uniform of the mobile position, make the seam an agent evenly into the gap, gap there is enough of the colloid. The seam an agent before use, to the front of 40 cm off without glue, these without mixing colloid not curing, not use inside the gap. And meet the ceramic tile of rough surface, also labeled for crepe paper glue in advance, otherwise the seam an agent on the ceramic tile is hard to clean up.

3,

pressure seam pressure joints shall be carried out after the glue, set aside a little time to make the seam an agent to precipitate into the gap of the seam pressure can also avoid the pressure when take away a lot of colloid. And seam pressure need to use the same kind of tools, to avoid a gap to use several tools, the magnitude of the seam pressure to be consistent, in this way can of the pressure level off is smooth.

4, plastic shovel

if glue was used in a different way, shovel glue differently. Shovel glue has two methods, one kind is with the ceramic tile of crepe paper, 15 minutes after the seam pressure will tear, crepe paper, don't wait until the seam an agent curing. One is smooth on the surface of ceramic tile, need to wait until the seam an agent curing totally shovel glue. With a shovel knife scooping up the seam an agent, the beauty of hard seam an agent can be directly with the hand torn off.