How to tile seam ( To the seam floor tile should pay attention to? ）

When laid ceramic tile is must leave a gap, because bibulous inflation will appear in the later use of ceramic tile, installation time may caused uneven tile ridges or other conditions, if there is no gap, can make whole ceramic tile surface damage. The seam an agent factory small make up today is to introduce how to tile the seam, seam floor tile beauty what to pay attention to.

how to tile the joints floor tile seam beauty now is done with the seam an agent, the construction technology is simple, learned we can own construction. Ready ahead of time in the process of floor tile of the seam need tools, glue guns, pick cone, pen knife, seam pressure rods, crepe paper, etc. , generally can be bought on the net a full set of tools, the price is not expensive. Ready to these before we can start the operation.

1, the first thing you need to clean the ceramic tile aperture, use the seam cone to ceramic tile seam shovel out a about 2 mm groove, so when doing the seam floor tile the quantity is enough, the area of the paste is bigger, it is not easy to appear fall off phenomenon. The gap must be cleared of ceramic tile, it is best to the inside of the dust to clean, such beautiful seam an agent to use will be longer.

2, and then put the seam an agent to twist the mouth, the seam an agent export requires less as far as possible, such ability can guarantee the material evenly, and then install it on the glue guns, squeezed in waste rubber mouth again after installation, then according to the size of the ceramic tile seam, and then use the knife to get a lateral incision.

3, sew the agent installed on the glue guns, sew the discharging mouth off, and then install on the discharging mouth, with scissors along the thick reinforcement in the discharging mouth cut slope Angle of 45 degrees, then discharging mouth width is the same as the width of ceramic tile, make best material mouth can completely into the ceramic tile seam.

4, when using the seam an agent needs to use first caulking agents at the bottom, make the beauty of the seam in flat aperture effect is better, so after the base level off strong, we can make the seam an agent with a glue gun.

5, seam an agent in the United States before solidification need to use a wet sponge wiped out more than expected, because it is difficult to remove after solidification.

6, use a sponge, the final clean up the beauty of the seam an agent, more beautiful seam an agent usually is quick-drying type, so we have a lot of time after the use of up to 50 cm with a damp sponge to overflow the beauty of the seam an agent, or stuck in ceramic tile edge will effect.

the seam floor tile should pay attention to what the

1, caulking, pay attention to time beautiful stitch work needs to be done in ceramic tile ceramic tile can only be carried out 24 hours after the shop is stuck, so ceramic tile in the shop is stuck is completed, still not strong enough, if directly on the seam, it is easy to lead to problems such as ceramic tile displacement.

2, choose good ceramic tile gap filling material

caulking materials currently on the market are mainly white cement, putty powder, the seam an agent of the three, white cement and putty powder on performance is insufficient, waterproof effect is poor, so you'd better choose the seam an agent, its performance is good, can thoroughly solve the problem of ceramic tile seam dirty black.

recommended articles:

seam floor tile beauty to do? （ How to improve the collocation of the

floor tile seam construction steps method.

home decorate floor tile seam beauty can do

the seam to do ( These points must understand)