Professional manufacturer of tile grout and adhesives with 27 years experience

How to use the seam gun? （ Not move to do)

2020-12-07

Kastar

132

With the continuous development of the sewing industry, there are many types of beautiful seam an agent, single tube of the double tube, so the seam an agent also has a variety of glue guns, normal we are recommend beginners the beauty of the seam when using manual seam an agent glue guns, electric is not recommended, is our factory ten years return the beauty of the seam an agent or manually glue gun. Manual glue guns use process will inevitably have some special cases.

how to use the seam gun

1. The gun installation

ready after pipe, now it can be loaded into the seam gun, holding grips, pull back out from the back-end rod at the same time, the older the seam may need to stem gun rotated 90 degrees to pull back, the latest beauty only need to slide back seam gun, will open the seam an agent tube into the spray gun in the mouth, nozzle in the front. Will open the front end of the nozzle glides across the gun, and then move it forward, hold down the trigger and manually will now connected to the push rod in the front of the disc to the backend.

2. Test the seam gun

after the installation is complete, use squeeze the trigger, feel beautiful seam an agent pipe resistance, pressure will force the seam an agent from the nozzle tip.

glue guns out of the question does not move how to return a responsibility?

check if the seam an agent glue gun under voltage or power, check the power supply and switch in time, when, after the expiration of the fill pressure to try again.

1, if the results from material valve control rotation Angle is too small, as long as the Angle of the valve to open slightly larger, to try a gun.

2, glue gun open air pressure control knob is too small, can also lead to the seam an agent glue gun can't discharge, available along & other; ＋” Giving directions, slowly rotating knob to the largest, try again.

3, if it is found that adhesive glue guns head congestion, usable steel needle or fine wire could hole through gently, or rinse clean with cleaning gun directly, do try reinstall the gun.

4, if you run out of gap filling agent, natural glue gun was not discharge, remove the cylinder to check whether there are more than expected, if not, change the new material in a timely manner.

5, device, pneumatic air leakage, can also cause gum gun can't discharge, item by item, check the equipment of pneumatic connector, only to see whether there is a leak phenomenon, and to a flat nipple tie ribbons, ensure good air tightness, if it is caused by airway cracking gas leakage, directly to replace the airway.