Sanming setting time: ceramic tile gap filling agent at room temperature, DJ - 03 high-strength non-shrinkage ceramic tile seam filling agent about 3:55 h initial setting time, final set time of about, h, the environment temperature is lower than 5 ℃, the setting time is slightly longer. Ceramic tile seam filling agent dosage calculation after zhengde technology many times test, 1 cubic meters need to ceramic tile seam filling agent is about 2. 2 tons, considering the construction process of loss, we suggest that you press 2 per cubic meter. 3 tons to procurement. Use of sanming ceramic tile seam filling agent products: (1) surface treatment 1, concrete surface should be clean, solid, no grease, oil, without cement laitance and adherent rickety little particles. Metals ( Iron and steel) The surface must be free of scale, rust, oil and grease. 2, all water base must use clean water to fully saturated infiltration, but should be done before construction base table without MingShui and small puddles. (2), mix 1, suggested water added to 13% per packet 15%. 2, 70 - first 80% advance weighing good clean water to join a clean container, then slowly while stirring constantly in packs of ceramic tile seam filling agent. Then add the remaining water and continue to stir 2 - 4 minutes, until blended. 1 - stop stirring, the status quo 2 minutes, and then continue to low-speed mixing 1 - 2 minutes. (3), 1, immediately will stir a good material for infusion, ensure the perfusion in the process of air to flow out. 2, equipment foundation grouting, make sure to provide enough pressure to maintain ceramic tile seam filling agent flow continuously. Mixing the materials must be completed within 30 minutes of grouting, and ensure that the construction must be continuous operation. In the case of difficult perfusion, can use the guide bar, but unfavorable use vibration equipment.
Contact Us
Better Touch Better Business
Contact Sales at Kastar.
Call Us
+86 13924533378