Study of ceramic tile seam ( Self-study tutorial)

Ceramic tile after the construction joints will learn knowledge

1. Ceramic tile on the beauty of residual seam an agent treatment

if ceramic tile contaminated time is not long, the pollution of the first places fully wetting, patience and wiped with cleaner, in patient with clear water wash should can go to a color, or can be directly with a certain concentration of alcohol washed away. Pigment has penetrated into the ceramic tile, can use the oxalic acid cleaning. If the above method is still not enough to solve your problem, you can also buy a special beautiful seam an agent cleaning agent.

2. The processing of pitting

for & other; Pitting & throughout; , when construction must be flat bottom seam cleaning clean, choose the quality of the products must be qualified. And use the porcelain white, backing the seam an agent, and then on the surface due to color the seam construction; If & other; Pitting & throughout; To be mild, also can consider directly on the pitting their positions on secondary due to color the slot in the construction.

3。 The seam an agent solidification time

true porcelain gum for 15 minutes under normal temperature 20 ~ 35 degrees Celsius can form a layer of protective film on the surface, after about 15 hours to thoroughly dry solid, the water porcelain need time will be longer.

4。 Seam beauty care

try to keep the ceramic tile in the normal temperature below 25 degrees, table 3 hours, 24 hours using strength, natural curing 7 days. Within 24 hours after the seam to avoid contamination, rain, water, avoid walking on ceramic tile.

self-study the sewing step

the first step: use clean seam cone clear aperture, and then clean up with brush crevice of tiny dirt, use the vacuum cleaner is a good choice;

step 2: stick or crepe paper tape along the crack edge well, be careful not to place them on crack, or after may leave a hole;

the third step: insert the hose on the seam an agent, and then loaded on glue guns and even hard to squeeze the seam an agent in the crevice;

the fourth step: use a spatula or seam pressure the ball joint, leveling remember to flow in the seam an agent when she was in time, if the full range wall all fill solidified blow again, will be tired to your doubt life. There is, first after the ground, metope to do first in the same direction, dried up to another direction, or intersections easy to bad. Extruded rather more not less, don't in the time of screeding found broken holes phenomenon;

the fifth step: smoothing can be torn off the crepe paper, don't wait for the seam an agent to do just to tear, otherwise may solidify together to tear out or take away part of the crevice of the seam an agent.

recommended articles:

ceramic tile seam where learning ( Read will be * *)

to learn where the seam ( This tutorial to ensure a learning will)

the seam how purify? （ This a few method worth learning) Don't do

home ceramic tile seam ( Penitence dead you)