The beauty joint agent does not cure slowly after construction, and the reason is unexpected-Beauty joint agent factory

When we use beauty joint agent to decorate ceramic tiles, we occasionally find this situation: after the construction is completed, after a long time, the beauty joint agent does not dry out, or it is not cured, and the curing is incomplete. So what is causing this, let's take a look with the editor. The properties of the beauty seam agent itself are not compatible. For example, the two components of product A and B need to be uniformly mixed in the ratio of: before they can be cured completely. However, this state is absolutely ideal. During the construction process, the glue on one side of the two tubes A and B will always come out first when the glue is first released. This will cause the beauty of the seam glue in the front section to be about cm. It is not mixed according to the ratio. If this section is not discarded during the construction process, and it is hit into the gap of the tile, it will cause the beauty joint agent to be delayed in curing. The inner core of the glue nozzle is loose. During the production process, due to worker errors and other reasons, the inner core of the original glue nozzle is loosened. During the construction process, the glue flows from the wall of the mixing pipe to the glue outlet at the front end, resulting in uneven mixing. , There will be situations such as non-curing. Glue nozzle incision is too small Some glue nozzles have too small incisions, resulting in increased sizing resistance, which will cause the A and B components of the glue to be discharged unevenly during use, which is also a situation that causes non-curing. The temperature is too high or too low. When using the beauty joint agent, the temperature should be between °C and °C to achieve the best curing effect. If the temperature is low, the glue will solidify slowly, and if the temperature is too high, the glue will not solidify easily. . Solution: Before construction, squeeze out the cm glue in the front section of the beauty joint agent and discard it. If the pause time exceeds minutes during the construction process, you must discard the front end cm glue again. So in order to save, it is best to The beauty stitching agent is used up at one time. 、Use a professional glue gun to check whether the bottled screws are loose and whether the pressure is balanced before construction; 、Use professional tools for the incision of the glue nozzle and cut according to requirements; 、If the temperature is low in winter, the glue will become very difficult. Thickness affects the construction effect. You can put the whole beautifying agent in hot water and then soak in the construction, so that the glue will save effort, the mixing effect will be better, and the gloss will be higher. Alright, that’s it for today’s sharing of knowledge about beauty sutures. See you in the next issue~~
Beauty Seam Agent Causes Not Cured