The construction joints when bad glue

Construction joints in the United States, believe that many people have met ceramic filled seam an agent it is difficult to play or play in the problem, then what is the reason lead to ceramic filled seam an agent is bad? Ceramic tile ceramic filled seam an agent today small make up take you to understand it.

1, if the results from material valve control rotation Angle is too small, as long as the Angle of the valve to open slightly larger, to try a gun.

2, glue gun open air pressure control knob is too small, can also lead to epoxy ceramic caulking glue gun can't discharge, along & other; +” Giving directions, slowly rotating knob to the big guns to try.

3, if it is found that adhesive glue guns head congestion, usable steel needle or fine wire could hole through gently, or rinse clean with cleaning gun directly, do try reinstall the gun.

4, ceramic filled seam an agent has a lot to do with the strong consistency of raw materials and the temperature, summer and winter change is more obvious, relatively thick winter will dilute the summer. If the weather temperature is very low, the gel may be slightly frozen, compare the thickened so be a bit of a bad play, small make up recommend before construction to the appropriate heating ceramic filled seam an agent.

5, the front end of the mixing tube of incision small flow rate is small, although very hard but discharge will slowly will be slightly difficult.

6, ceramic filled seam an agent to place time is too long, can cause difficult phenomenon.

in addition, when purchasing a glue gun and ceramic filled seam an agent products, need to buy quality and reliable. If the poor quality of glue gun, glue gun play material pressure is too small, will naturally affect the construction effect; If the poor quality of ceramic filled seam an agent, may also directly blocked the export of glue gun.