The joint training

Tools: MK - 112 pairs of pipe plastic glue guns or advanced double iron gun, thin rubber gloves, tools, knives, sponge ( Even the best sponge mop head, remove the back of the plastic sheet) , rags, bucket ( Wash sponge with) And small nails ( Need not when stopped discharging mouth) Qing court: sew brick dust clean, especially the hem of the cement seal, to cut clean. Brick surface cleaning, especially on both sides in brick joints can not have dust.

warm prompt:

to understand deep seam problem, which is the thickness of the ceramic tile, if may also directly bring a beautiful deep seam of ceramic tile aperture, but consumes beautiful seam an agent, the dosage of 2 - proposal ceramic tile aperture depth 3 mm is suitable.

as seam deep advice render caulking, use common caulking agent ( White cement) To fill up ceramic tile aperture.

it is very important to the last step, after waiting for caulking agent of dry, open 2 - seam an agent gap The depth of 3 mm, usable and ceramic tile aperture width small 1 mm slot machine also can be replaced iron wire, wire wire, clean aperture can be beautiful seam. Operation: the first seam an agent discharging mouth open to open the back cover, install discharging mouth, the discharging mouth with paper knife cut into the slope Angle of 45 degrees, the discharging mouth width should be keep consistent with slit width. The beautiful seam an agent into glue guns, slowly expiratory will right amount, evenly into the slot. Crowded seam about a metre long with sponge flat brush, brush along the seam, the strength is smaller, don't rub seam in the material ( Remember to bring gloves) 。 Beauty on both sides of the seam an agent to brick, to promptly clean, dry can also use the blade row. Sponge to clean in time, brush a few times more. The seam after ceramic tile within an hour, do not touch the ash and water don't pressure deformation.