The seam an agent how to use ( Two step)

After ceramic tile shop, as well as an important procedure, that is to make the seam an agent.

step one: crack-cleaning

the beautiful seam an agent into glue guns, then slowly expiratory material evenly into the slot, play together, 0. 2 meters) After using wedge block of material mouth first, then use the wiper or finger to the seam an agent, leveling immediately on both sides of the brick seam spilled material can wipe off with a wet sponge, must seam an agent in the United States didn't wipe clean before solidification. Sponges to clean with water after every erase, in order to continue to use the next. If the seam in more than 3 mm wide, fill in the beauty of ceramic tile seam seam an agent and more uniform, so don't blow the seam an agent, let it flow flat automatically.

step 2: make gum

1 mm deep cracks. Before construction of the seam an agent with dishcloth or lint brush to clean up dust and other magazines seam. On both sides of the seam with crepe paper. 0 to crepe paper from the crack edges. It is advisable to about 5 mm. Will the seam an agent is installed on the glue guns, along the seam evenly into the brick. Construction of about 1 m, immediately with your finger or little wiper evenly daub; While the seam an agent without solidification ( Construction about 1 meter) , remove the crepe paper.

recommended articles:

floor tile seam construction steps method.

the ceramic tile seam an agent construction procedure steps ( Quickly learn)

the seam an agent to reconcile the construction steps illustrated the seam an agent to reconcile the construction diagram