The seam gun can't remove the pack?

The seam gun can't remove the pack?

may be the glue gun is broken, or the installation step is wrong, can be in accordance with the instructions said that according to the steps to tear open outfit.

the seam gun pull don't come out how to solve?

1, if material valve control rotation Angle is too small, can cause the gun does not come out, need to open the valve Angle can be larger.

2, if the gun pressure control knob is too small, can be used along & other; +” Giving directions, slowly rotating to the largest, try again.

3, check the glue head gun jams, usable steel needle or fine wire hole will get through, then sew the spear is rinsed clean, do try reinstall the gun.

4, if ran out of the seam an agent, glue gun dozen don't naturally discharging, can remove the cylinder, check to see if have everything expected, if not, change the new material in a timely manner.

5, when the equipment pneumatic leak, can also lead to gun to pull out, item by item, check the equipment of pneumatic connector, see if there is a leak phenomenon, and to a flat nipple tie ribbons, ensure good air tightness, if airway cracking caused by the leakage, the airway can be directly replaced.