The three key of ceramic tile shop sticks acceptance, step by step by step wrong wrong

Everyone knows that in decorating, spend the most hard part is a bricklayer's, bricklayer's construction is very important for the whole home outfit. If there is no well, later will appear all sorts of problems, may also exist some safety hidden trouble, small make up ceramic tile shop sticks are summarized for everyone today acceptance of three key, let's take a look at.

roughness, slope

1, the toilet threshold stone than toilet ground 1 cm high 1. 5 cm, prevent toilet water to spill

2, shower, kitchen, not sealing balcony ground window, to the direction of the floor drain ground slope, slope is 2%, the catchment is smooth.

3, the flatness requirement of the floor tile is between the brick and tile flatness error is less than 0. 5mm。

4, wall brick allowed error is 0. 5 mm

empty drum

avoid empty drum ceramic tile, pay attention to the following

1, the binder surface evenly to

2, pay attention to the seam, brick and tile between 1 to 3 mm, cracks and crack error is less than 1 mm, avoid empty drum heat bilges cold shrink

3, thoroughly clean ceramic tile back mortar and grassroots surface

4, wet shop, the choice of thin paste, about 3 - thin stick 5 mm, wet laid about 20 mm

5, after the shop is stuck in a timely manner on the ceramic tile, increase the cohesive force

6, ensure that the ratio of 1:3 cement mortar, to ban the use of already coagulation mixing cement mortar

7, glazed tile bubble water to 2 hours, to avoid premature absorbs moisture, mortar appear empty drum

still need to pay special attention to: finish waterproof bathroom, too smooth, not hanging nets, can do processing, hair increase bonding degree

tile founder, crack problems

1, the floor tile with the size of aperture alignment, pull the reticle, somehow the seam penetration may not break, floor tile seam 1 mm wide, must not exceed 2 mm

2, floor tile and wall junction seam is not more than 5 mm

3, floor tile reasonable boundary brick row feet, edge horn cannot appear within 10 cm of small article

4, windowsill stone bay window stone wall edge to be in need to lengthen 2 cm at both ends and add strength to embed wall

5, switch socket opening of ceramic tile surface error is not more than 2 mm