Their joint ( A few minutes to learn)

When do the seam, a lot of steps have a point, can't take it for granted. If the master, owner, please be professional construction can use this time to test their professionalism; If the owner is do-it-yourself construction, I believe these will help you better finish construction!

your beautiful seam must pay attention to the point of the

1.

do not clear gap directly construction before the seam, ceramic tile aperture must clean up, don't have obvious dust and water damage. Some owners get very excited after the seam an agent, not clear immediately construction. At this time, the gap in a lot of dust, some very damp, there are obvious traces of caulking. The seam an agent can appear in it, pale, fall off wait for a circumstance, it is very serious.

2. Gap cleaning the deeper, the better the

gap must not only clean, also should have certain depth, the best depth of ceramic tile aperture at about 3 mm. Many owners are worried about the depth of the crack is not enough, the seam an agent is easy to fall off, but the adhesion of seam an agent not only has asked to the depth, the gap on either side of the clean degree also have requirements. Gap, is, the more the demand for the seam an agent, also increased the difficulty of the crack-cleaning.

3. Immediately after ceramic tile to stick a good beautiful seam

just stick good ceramic tile, crack in the clean and dry, very suitable for the best, but many owners in ceramic tile just stick a good start to do the seam. Should wait until good ceramic tile stick completely dry before the seam, just stick good at the bottom of the ceramic tile is damper, affects the solidification of the seam an agent.

4. Rough surface of the ceramic tile glue directly

surface smooth ceramic tile can directly construction glue, surface roughness of ceramic tile, need to be labelled as crepe paper, or on the seam wax to make gum. But many owners think it too troublesome, or don't know what kind of ceramic tile to rough surface, hence directly make gum, the result finally beautiful seam an agent destroying glazed ceramic tile, can root out directly.

5. Finished glue immediately after our game adhesive seam pressure

need to wait for the seam an agent to precipitate in a short while again seam pressure, so as to ensure that there is plenty of beautiful seam an agent into the gap, to avoid wasting the seam an agent, extruding flat aperture. But if finished glue immediately seam pressure, may be a lot of beautiful seam an agent will be as seam pressure tool away, only a small amount of in aperture.

6. The seam shovel immediately rubber

shovel glue is divided into two cases, one is posted, crepe paper is a kind of wax or directly make gum. Both of which can't press the seam immediately shovel gum, colloidal not stem, will crack the shovel off together. Can be finished with crepe paper adhesive torn off after 10 minutes, wax and direct glue, need to wait for the seam an agent curing totally shovel glue.

make your own beauty seam

1) the first is the cleanup.

if there is a surface protective film, blow be bored with child before work difficulty is greatly reduced at this moment, need the seam position emptied, clean ground, especially the crack surface location.

can purchase professional cleaning kit (a treasure to the above Dozens of more than one hundred range) , or you can prepare a word screwdriver, wallpaper knife, tongs, brushes, gloves. This is slowly, relates directly to the beauty of flatness, try to sort out brick seam between the trash, a vacuum cleaner buddy can be twice gap, if not slowly brush with the brush can clean clean!

(2) brush the seam wax because the seam late need to clean up the edges, brush again the first seam wax, finally clean up can save several times more than ten times as long!

3. Start the joints after the first wall, construction along the edge directly at the end of a line, don't stutter! Waste materials do not say the overall effect is poor, work is smoothly!

tip: in a bevel cutting, rubber head position slightly stretching can more spare glue.

4. Flatten the seam an agent

you can use the professional edge ball, ball pressure ball pressure Angle of Yin and Yang, also can buy ice stick ( The east hotel supplies store sell) , by inside and outside construction cross location.

5. Clean the seam an agent

in the seam an agent 6 hours to dry, dry wood Suggestions for 24 hours, and then use the shovel ( If the seam with the wax many can kick) directly Clean up the gap.

recommended articles:

at home to do the seam really easy?

the home installs the seam is necessary? How to make their own beautiful seam

the seam to do ( Two minutes to learn their beautiful seam, save money and effort)

the seam on yourself? （ First to know the five pitfalls)