【Tips for beautiful seams】How to deal with bubbles when making beautiful seams? -Beautiful seam agent factory

When making beautiful seams, you will encounter many problems, and foaming during beautiful seam construction is one of them. If you look carefully after the beautiful seam construction is completed, sometimes you will see a lot of bulges. The small bubbles are very unsightly. Why does this happen? How to solve it? , The grassroots is not properly treated, the drying is not thorough, and there is moisture in the cracks of the tiles. Be sure to keep the gap dry before construction, otherwise it will cause the discoloration and whitening of the beautiful seam, and at the same time, as the water vapor evaporates, it will cause the beautiful seam to bubble. , There is dust in the cracks of the tiles, which have not been cleaned up. It is difficult to clean the dust in the crevices with a brush or broom during the beautiful joint construction, so you must use a vacuum cleaner to clean it thoroughly. Prevent dust pollution, and then can prevent unevenness of the made beauty joint agent. , The tile gap is too small, and the construction speed is fast. There is a pause during the gluing or the gluing is too fast, the glue does not enter the gap, but on the surface layer, the air volume pressures the bottom layer, and the gas inside cannot be discharged when the gap is pressed, which causes the glue to bubble. , The thickness of the beautiful seam construction is too thin, and it is not fully filled. If the gel is too thin, it will not be enough to compact the air inside, and it will easily lead to blistering. , Transportation bumps cause air intake. Long-distance transportation will inevitably cause bumps. A small amount of gas will enter the bottle. Before construction, open the bottle cap and push the piston with a glue gun to expel the air until the two pipes are out of material at the same time before installing the mixed glue stick. , The quality of Meisewn products is poor. Inferior quality stitched products, due to the backward production process, the colloid is mixed with a lot of gas during the production process, resulting in bubbles during construction. , The heating temperature is high, causing the colloid to have bubbles. In winter, the temperature is low. In order to reduce the difficulty of glueing, heating is often used to solve the problem. But if the temperature is heated too high, bubbles will easily appear. When heating, the mouth of the bottle is upward, and the temperature is controlled at about -degree. Generally, there is more than one reason for the appearance of bubbles. It may be caused by a variety of factors. Strictly operating in accordance with the specifications will greatly reduce the appearance of bubbles.
Bubble Beauty Stitching Agent Factory Beauty Stitching Skills