What a beautiful Mosaic tile seam, the shop is stuck

Mosaic tile has the very good adornment sex, it is widely used in kitchen, toilet, exterior wall decoration, general in rural villa or used in the decoration of the house is so much more, because of the way of collocation of all kinds of ceramic tile, can make a lot of effect, therefore are popular with people, so a beautiful Mosaic tile seam an agent construction?

the Mosaic tile joint?

exterior wall as an outdoor beauty of ceramic tile ceramic tile seam an agent or the use of relatively little, but not not beauty, but based on the construction of the building environment, the outer wall of ceramic tile seam will be higher than interior wall, construction difficulty and beauty sewing effect but may be not as good as interior wall, mainly has the following several factors:

exterior high humidity

outer wall in the outdoor environment, morning and evening mist is very heavy, the crack inevitably wet fog. External wall can not guarantee outdoor temperature at the same time, for the time is more long.

construction risk

construction process, is more dangerous, because of high aperture beauty basic can only be carried out by means of a ladder, should pay more attention to when climbing, crawling, otherwise very prone to accident. Gap width and length

this is the common fault of the exterior wall tile, exterior wall tiles will seam is compared commonly wide, thus affecting the seam an agent dosage, so cost far more than indoor construction. Combined with Mosaic tiles is inherently belongs to small ceramic tile, no doubt adds to his construction length, very not bargain.

at the same time, exterior wall tile main protective effect, is not is beautiful performance, although you can do the seam, but not the necessary. Specific can consult: what is the external wall tile, exterior wall tiles can do the seam.

how shop sticks ceramic tile wall

1. Handle basic

if the basic unit is a concrete wall, need to protrude the stuck between concrete flat of metope, if too smooth at the grass-roots level, to roughen processing; At the grass-roots level for the brick wall surface, wipe base gray before, need to clean metope, handle the window and the window is covered, waist line, such as damage, loose parts, water wetting metope.

2. To plaster

base ash, the procedure generally require a second operating points, is a wipe on a thin layer, use float compaction. The second is to use with a base of mortar mixing the ash by screed, dips fill and level up, and textured, with wood float to rub out the final set and water conservation.

3. Wall elastic line

want Mosaic tiles paste tidy and beautiful, so, before the formal shop is stuck, most people will measured the width and height, pop-up uniform horizontal line on metope, then according to the elastic line, shop sticks ceramic tile in turn.

4. With stick Mosaic

ready, go to the shop is stuck Mosaic. First of all, on the metope besmear water mud sand, according to the order of the Mosaic on the wood plate, and filling sand cement in the ceramic tile aperture, excess cement sand blowing, and then bottom-up Mosaic tiles of the pavement.

although the beauty of the seam is not recommended to do Mosaic tile but indoor can try, the effect is very good, The Mosaic tile joint rendering) 。