In terms of the relative to traditional cement, ceramic tile glue craft is advanced, and very save dosage, can guarantee the quality of engineering and environmental protective, it is a good choice of home decoration. But at the time of ceramic tile of choose and buy the glue, must according to the size of the brick or paste, material, and indoor and outdoor to choose ceramic tile adhesive type. A lot of people always think when decorating the use cost is higher than the cement ceramic tile adhesive, and then want to add cement or sand to use ceramic tile adhesive, actually this is not desirable, because at the time of use should be considering the construction process, the requirement of construction technology of master or select the right type of tile glue than with the safety of the cement series number is much higher, and the cost is almost. In the use of ceramic tile adhesive, if use undeserved, then paste the effect will be discounted. Here are several kinds of errors when using ceramic tile adhesive:
error 1: shop sticks ceramic tile when adding cement or sand into the ceramic tile adhesive, etc. Adding cement and sand in ceramic tile adhesive, easy to cause the product quality cannot be guaranteed, but also easy to shop when tile to fall off the empty drum.
2: wrong use ceramic tile adhesive on the ground to ceramic tile glue if you use a spade shovel stirring which is unable to mix, ceramic tile glue so effective chemical components inside it is easy to loss, and stirring can cause material ratio is not accurate, easy to cause the loss of ceramic tile adhesive stick relay.
mistake 3: use bubble to ceramic tile glue to use. Habit of a lot of construction personnel in accordance with the method of bubble cement use ceramic tile adhesive, then add water, easy to make no strength of ceramic tile adhesive, powder, and even reversed.
error 4: ceramic tile adhesive water mixing use again after use time is too long. Ceramic tile adhesive mixing after effective components have taken place in a chemical reaction, again will only change the operating performance of water, can therefore lead to later bond strength is not enough, ceramic tile adhesive should use increases with the increasing stirring, using time control within 2 hours, should be discarded after the dry solid.
error 5: point construction, and do not knead ceramic tile. Place empty drum ceramic tile corner, damp environment for a long time can lead to falling bricks; Ceramic tile is not pressure, mucilage binding not firm; Ceramic tile adhesive should be thin stick method of construction, according to the flatness and ceramic tile size at the grass-roots level to determine the appropriate tooth scraper, knead paste should be pressed in place, and random check on the back of the full rate of pulp.
6: wrong cloth glue area is too large, mucilage dry solid surface. If the glue area is too large, if outdoor dry or windy weather is relatively easy to cause the surface of the mucilage dry solid, so easy to drop brick tile, tile best when the area of the cloth and rubber within one square metre, if metope can dry prewatering metope.
7: wrong on the surface of the untreated base oil, sand, stripper and empty drum has direct stickup ceramic tile. Base if there is oil or low will affect the ceramic tile adhesive bond strength, it is easy to cause the empty drum ceramic tile brick, base tile again if do not conform to the requirements must handle in advance.
Contact Us
Better Touch Better Business
Contact Sales at Kastar.
Call Us
+86 13924533378