What are the problems should be paid attention to when the seam ( It is important to note that for details)

In order to make ceramic tile aperture more good-looking, many people choose to make ceramic tile seam beauty, make ceramic tile aperture also can keep the effect of beautiful, but do the ceramic tile seam when should pay attention to? Ceramic tile for the seam, if not pay attention to in the small details, out effect also sent a lot, ceramic tile seam beauty details have?

what are the problems should be paid attention to when the seam

1, need to clean the ceramic tile aperture

use the seam cone to ceramic tile seam shovel out a about 2 mm groove, so when doing the seam floor tile of the quantity is enough, the area of the paste is big also, it is not easy to appear fall off phenomenon. The gap must be cleared of ceramic tile, the dust inside also to clean up, such a beautiful seam an agent to use will be longer.

2, the seam an agent export requires less as far as possible

this can guarantee the material evenly, and then install it on the glue guns, squeezed in waste rubber mouth again after installation, then according to the size of the ceramic tile seam, and then use the knife to get a lateral incision.

3, the seam an agent discharging mouth width should be the same as the width of tile

the beautiful seam an agent discharging mouth off, and then install on the discharging mouth, with scissors along the thick reinforcement in the discharging mouth cut slope Angle of 45 degrees, make material mouth can completely into the ceramic tile seam.

the ceramic tile seam detail what are

1, guarantee the construction base must be solid, smooth, no dust.

2, be consistent in ceramic tile seam width available plastic cross positioning, otherwise affect beautiful.

3, discharging mouth mouth to small discharge to evenly, each finished, jointing again when discharging mouth since a small amount of material overflow.

4, discharging mouth width is almost consistent with the slit width, such ability make sure ceramic tile fabrics can completely covered the base.

5, caulking discharge must even less not more easily, note a long 1 m or so can't scrape to evenness immediately over a period of time to scrape the seam an agent surface local brick seam lacking beauty seam an agent can fill again when cleaning.

6, in the cross interface more small brick construction should be painted in the first vertical seam, then apply the principle of the horizontal seam, in the cross intersection, here, note the seam an agent after scraping to skip blow gently, make less beautiful seam an agent into the cross stitch.

7, the seam an agent after the initial curing, with a slightly damp sponge to redundant caulking agent on the surface of the ceramic tile is clean. If cleaning not clean can also be beautiful.

8, ground after construction, can walk after 24 hours, 72 hours with no brick dust exposure to sew the seam an agent.

recommended articles:

the seam construction should pay attention to what points?

make your own beauty seam, these considerations need to know

the seam an agent should pay attention to the basic common sense

the ceramic tile seam, when is the best time to do? Need to pay attention to what?