What is installation GTPS bearing pedestal of mortar

1 bearing support mortar mortar usage support mortar manufacturer. GTPS bearing device, reliable way, must be taken to ensure the bearing force uniform. 2. Pot rubber bearing device before the site should be to check the bearing connection situation is normal, not arbitrary loose upper and lower bearing plate bolt connection. 3. Bearing device before cut hair bearing pad stone surface, clear away the clutter in the anchor bolt holes, using the template, grouting and water will be bearing pad soaked stone surface. 4. Device support in place, steel wedge wedging bearing corners, leveling pedestal and adjust the support to the design elevation, between the bearing base and bearing pad stone should be 20 ~ 30 mm. 5. Take a closer look at support center position and elevation, with high strength not shorten the pedestal mortar grouting. 6. GTPS pedestal at the bottom of the mortar gravity grouting is infusion support and anchor bolt hole space, should support center around grouting grouting process, from the template and bearing clearance surrounding the floor until observed all fill up bearing mortar. Grouting slurry volume amount should start accounting need, before the actual number of grouting body accounting and should not be excessive error value, avoid center of pulp. 7. Bearing mortar after the final set, dismantling formwork and steel wedge, check whether there is a leak slurry, to fill slurry, slurry leakage place and take out after clearing difficult steel wedge, tighten the bearing plate anchor. 8. After the grouting, GTPS bearing mortar for maintenance.