Analyze common misunderstandings in the beauty joint construction for you!

Analyze common misunderstandings in the beauty joint construction for you!

The beauty seam agent is becoming more and more popular in the market, and there will always be many problems with the development! In the process of the beautiful joint construction, many people will feedback the problems such as poor effect and difficulty in construction! Beautiful seam construction is a technical job, and any carelessness will affect the overall construction effect. Novice beauty sewing masters will also make some mistakes during construction. Have you ever made the following mistakes? Hurry up and follow the beauty sewing agent manufacturers to take a look!

　　1 The tile gaps are not cleaned and directly applied with the joint agent

　　 If the dirt in the tile gap is untreated, it will seriously affect the service life of the beauty joint agent. The correct way is to clean up the debris in the joints with a rag, fine-bristle brush or vacuum cleaner before the construction of the beautiful joints.

　　2 Immediately after construction, apply seam beautifying agent

　　 Press and seam immediately after construction, which may cause the material to not fall into the seam, but if the material is cured for too long, the effect will not be pressed and the gloss will also be affected. The correct pressure joint time is about five minutes after the construction for a period of time, the best effect is to carry out the pressure joint.

　　3 Immediately after the tile is laid, the beautifying agent will be applied

A major requirement for the construction of 　　mei joint agent is that the cracks of the tiles must be kept dry. After the tiles are laid, it takes a period of time before the moisture inside can dry out. If the beautifying agent is applied just after the tiles are laid, it will affect the effect of the beautifying agent.

　　4 One-time beauty stitch is too large

　　 I chose the color of the beauty joint and started construction happily. After the construction was completed, I found that the color and the tiles did not look good. At this time, there were only two ways to remedy it: shovel the beauty joint directly out Then refill the new beautifying agent, or inject new beautifying agent to cover the original beautifying agent.

　　 The former is more costly, while the latter can save costs but the effect is not great, and the use time will not be very long. So the correct way to use it is to try a short section first to see the effect. If you are not satisfied, you can change the color at any time without causing unnecessary trouble.

　　 Are these common misunderstandings in the beauty joint construction that you have encountered? After reading what the editor has summed up for everyone, we must pay extra attention to the details in the future construction. I hope that what the editor talks about today can be helpful to everyone. For more information about the beauty seam agent, you can log in to the official website of Wuhan Building Materials Co., Ltd. for more consultation! Our customer service will be at your service 24 hours a day!