Beauty joint construction process-beauty joint factory

Beauty joint agent is an upgraded product of joint sealant. It is refined from a variety of high molecular polymers and high-grade pigments, which completely solves the troubles caused by white cement and joint sealant (joint agent) Really make your tile joints bright as porcelain, never dirty and black again. After the beauty joint agent solidifies, it will form a smooth, porcelain-like clean surface on the tile joints, which is wear-resistant, waterproof, oil-proof, non-staining and excellent Self-cleaning, not easy to hide dirt and dirt, easy to clean, wipe clean, its hardness, bonding strength, service life and other aspects are better than the caulking agent (grouting agent), which can completely solve the common tile joints Dirty and difficult to clean. It can be used whether it is a newly decorated tile joint or a tile joint that has been used for many years. Avoid the breeding of molds in the crevices and endanger human health. How to apply beauty joints? Next, the beauty joint agent expert from the US joint agent factory will introduce to you the construction process of the beautiful joint agent.

The construction process of the beauty joint agent:

, first do the preparations before construction, deal with the tile joints, use a small shovel to shovel the tile joints into a groove with a depth of less than one millimeter, so that it is not only convenient for the beauty joint agent, but also the beauty joint agent is stored in this groove It can also avoid excessive wear in the future.

, and then use a small brush to clean up the dirt that was shoveled out.

、When the preparations are done, you can open the beauty joint. First use a small awl to open the beauty joint, and then install it on the glue gun. Because the method of installing the glue gun is relatively simple, follow the brick seam hit.

, pierce a tile gap and immediately use a scraper to smooth the tile gap beautifying agent.

. The current new type of beautifying agent is quick-drying, so if it is a few centimeters, it must be cleaned with a wet sponge, otherwise it will be difficult to clean.

, the surface is completely cured within two hours after the construction is completed, and the construction surface can be used normally after one hour.