Beauty joint wall construction methods and techniques-beauty joint factory

The construction methods and skills of the beautiful joint agent wall, first prepare the stone to be used and the beautiful joint agent you choose to use.



、First, wet the base surface of the wall with clean water and wait until there is no clear water on the surface.



, Confirm that the thickness of the special artificial stone adhesive for scraping on the base surface is more than mm, and the thickness of the back of the stone is-mm, and then paste the stone.



、Be sure to paste the stone within the specified time. When pasting, twist and rub the stone up and down or tap lightly with a mallet. This is to make the stone and the adhesive adhere closely to the wall and tile The US joint agent construction team can also add copper wires to fix it according to the design requirements.



. Correct the joints between the level and the adjacent boards. Pay attention to the seams of mm or more between the stones.



、Preliminarily clean the dirt attached to the surface of the board, and after the stone has been pasted (according to the relevant instructions), the joints can be cleaned and filled. When filling the joints, you should use professional seamage seam agent .



、Clean after filling the joints. After the gaps are applied, clean up the excess beautifying agent on the surface of the tiles while they are not dry.