Do the seam should pay attention to 6 big mistake1

The beauty of beautiful stitch sewing division should all know, a lot of steps to have a point, not in the case of you don't understand, in the construction joints. If the master, owner, please be professional construction can use this time to test their professionalism; If the owner is do-it-yourself construction, I believe these will help you better finish construction! The seam construction must be done according to the steps, the correct order is: crack-cleaning, with seam, stick or the seam wax crepe paper glue, glue, seam pressure, a shovel, check acceptance, the seam an agent construction process, according to the order of the construction. Often still can't avoid the seam several blunders that existed in the construction of the following is said about the beauty of construction joints, common 6 big mistake. 1. Not clear gap directly before making the joint construction, ceramic tile aperture must clean up, don't have obvious dust and water damage. Some owners get very excited after the seam an agent, not clear immediately construction. At this time, the gap in a lot of dust, some very damp, there are obvious traces of caulking. The seam an agent can appear in it, pale, fall off wait for a circumstance, it is very serious. 2. After finished seam pressure immediately after adhesive needs to wait for the seam an agent to precipitate in a short while again seam pressure, so as to ensure that there is plenty of beautiful seam an agent into the gap, to avoid wasting the seam an agent, extruding flat aperture. But if finished glue immediately seam pressure, may be a lot of beautiful seam an agent will be as seam pressure tool away, only a small amount of in aperture. 3. The seam pressure immediately spade shovel adhesive is divided into two cases, one is posted, crepe paper is a kind of wax or directly make gum. Both of which can't press the seam immediately shovel gum, colloidal not stem, will crack the shovel off together. Can be finished with crepe paper adhesive torn off after 10 minutes, wax and direct glue, need to wait for the seam an agent curing totally shovel glue. 4. Gap cleaning the deeper, the better the crack not only to keep clean, also should have certain depth, the depth of the ceramic tile aperture is best at about 3 mm. Many owners are worried about the depth of the crack is not enough, the seam an agent is easy to fall off, but the adhesion of seam an agent not only has asked to the depth, the gap on either side of the clean degree also have requirements. Gap, is, the more the demand for the seam an agent, also increased the difficulty of the crack-cleaning. 5. Immediately after ceramic tile to stick the seam just stick good ceramic tile, crack in the clean and dry, very suitable for the best, but many owners in ceramic tile just stick a good start to do the seam. Should wait until good ceramic tile stick completely dry before the seam, just stick good at the bottom of the ceramic tile is damper, affects the solidification of the seam an agent. 6. Surface roughness of the surface of the ceramic tile glue directly smooth ceramic tile can direct construction glue, surface roughness of ceramic tile, need to be labelled as crepe paper, or on the seam wax to make gum. But many owners think it too troublesome, or don't know what kind of ceramic tile to rough surface, hence directly make gum, the result finally beautiful seam an agent destroying glazed ceramic tile, can root out directly. Conclusion: for seam ready to want to do myself, and I don't know how to operate, the six major traps need to know, to avoid in the construction joints, unnecessary trouble.