How to do balcony waterproofing, this article will tell you all-beauty seam agent factory

Although there is not much water used in the balcony, it is also one of the places prone to leakage. In particular, some families place washing machines and laundry tables on the balcony. If the waterproofing work is not done well, it is easy to spread indoors. Moreover, if the balcony is soaked in water for a long time, it will also cause the inner wall to peel and peel, which is very disturbing. Today, the editor will popularize some knowledge that you need to know about balcony waterproofing. Waterproofing of the balcony floor The floor of the balcony must be waterproofed with waterproof coating. Not only that, but also pay attention to the balcony drain. In order to prevent rainwater from entering the room, we need to have a certain slope when decorating the balcony, and the lower side is the drain , To ensure that the water can flow smoothly to the drain hole and not enter the room. Generally, the balcony and the living room must have a height difference of at least ~ cm. Waterproofing of the balcony wall The balcony wall is also recommended to be waterproof, especially around the windows. Rain will cause the wall to become damp, and long-term rain will also cause mold and cracking on the wall of the room, so it is necessary to do waterproof and moisture-proof. Generally, the painting height of the balcony waterproof coating needs to be at least cm. If it is the area where the washing machine is placed, the waterproof coating needs to be painted higher. Waterproofing of balcony window seams When wind and rain come, the first waterproof seal is the balcony doors and windows. The window gap is the most vulnerable place for water seepage. Therefore, we should pay attention to the quality of doors and windows, and the airtightness is also very important. Pay special attention to the inner and outer directions of the waterproof frame. Note for balcony waterproof construction: The waterproof layer is not exposed on the surface, so when doing waterproofing, you must first find the previous waterproof layer. , After removing the previous waterproof layer, level it and drain the water in the lower insulation layer. , After finishing the waterproof layer, it is necessary to find the slope, otherwise it will form part of the roof water, generally use cement mortar to level the slope, and the slope of the slope is not less than %. After the waterproofing is done, a water test should be carried out. If there is water leakage, it means that it is unqualified, and maintenance and tile decoration should be carried out. , The last beautification. When the balcony is beautified, do not damage the waterproof layer below. If it is damaged, repair it in time. The self-repairing waterproof coatings of the US joint agent factory strictly pass the environmental protection test and water-based waterproof coating standards. It is suitable for waterproofing absorbent surfaces such as bathroom floors and walls, kitchens, balconies, etc. It has good water resistance, alkali resistance, and high adhesion. It is non-toxic and harmless, and it is a truly ideal environmentally friendly material. The characteristics of the self-repairing waterproof coating of Meijiao factory: It has a strong self-repairing function and can heal cracks and damaged waterproof layers by itself. , The elongation is large, the coating is tough, water resistance, corrosion resistance, and durability are superior. , Easy to use, just mix and stir evenly in proportion to brush. , The construction requirements are low, and the base layer is wet and dry without affecting the use. , Strong resistance to shrinkage, repairing ability after repeated cycles of dry and wet. We are serious about making waterproof accessories.
Waterproof balcony