How to solve the problem of pipe burst, material thinning, and backflow after heating the beauty joint agent? -Beautiful seam agent factory

Temperature and climate change make it difficult to hit the beauty joints in winter, which is always a problem, especially in the north in winter, even if the glue gun is broken directly! This is undoubtedly a challenge for the seamstress. In the winter beauty seam agent factory, many masters of beauty seam have a very good solution to this problem, that is, soak in hot water. This problem is solved, but this problem is solved, and it is accompanied by New problems: leakage, pipe burst, thin material, backflow, etc. Is it true that the Jing Porcelain King of the Beauty Seam Factory can not soak it casually? How to solve a lot of problems after foaming? We all know that the beauty joint agent is composed of epoxy resin material and curing agent. The temperature in winter is low, especially in northern areas. At low temperatures, the curing agent and resin have a high viscosity, which leads to the increase of the consistency of the materials in the A and B tubes. The reason for the expansion and contraction in winter is the increase in the resistance of the bottom piston, so the seam is beautiful It’s hard to shoot out. The beauty seamstress of the beauty seam agent factory, but the hot water soaked the material well, but the problem came. The epoxy resin is very sensitive to temperature and suddenly heated, resulting in unstable performance of the epoxy resin. The longer the bubble time, the more unstable it will lead to problems such as backflow and particle impurities. For these problems, we give the following suggestions: First: The water in the foam should not be overheated, generally around the degree-degree, and different products should be adjusted appropriately. Second: The soaking time should not be too long, usually in warm water for one minute. For the specific length of foaming time, please consult the beauty seam agent manufacturer. Third: When foaming, remember to soak the whole bottle together, not just one side, which may cause a grainy texture due to uneven heating, and uneven color after being beaten. Fourth: When soaking the material, it is best to make the discharge mouth upward, and the water level should not exceed the position of the top glue outlet to prevent internal water from entering and air bubbles! Winter heating beauty grout factory beauty grout

Beauty seam agent heating tube bursting thin material backflow