What aspects of playing seam considerations include1

Ceramic tile seam beauty at the seam, in addition to the human reason, the stand or fall of glue gun is one of the factors, which affect the effect. But there is something wrong with the quality of glue guns can cause the seam an agent not stem, fall off, even the emergence of problems, such as tube blasting harm none. So the seam needs to choose and buy good quality glue guns, ferial should also be fit for the glue guns to do regular cleaning, maintenance, in order to prolong the service life of the glue gun. The general common ceramic tile seam is straight line, can play a distance across the line first, and then the longitudinal play; Also can follow after the first vertical cross construction principle; According to certain order to chaos is not recommended construction; As far as possible in the seam after skilled construction, avoid the intermittent, potholes. Cross stitch seams for mastering the shoes, not only ensure the full uniform of aperture, and try to reduce the waste due to alternate construction. Cross crack seam pressure processing is particularly important, radiation pressure along the center to the periphery seam, can be more uneven pressure twice. Cross aperture processing is the test of the sewing craft key nodes, the processing of the interface must be natural smooth, like nature itself. A material played again to rest as far as possible, if the rest more than 20 minutes, the mixing tube products began to solidify, cannot use. At this point can be preserved together with the mixing tube directly, wait until the next construction, tube can directly replace mixing raw material. In construction of ceramic tile seam beauty don't save and deliberately reduce dosage, recommend every time into the beauty of the seam an agent is higher than 2 mm on the surface of the ceramic tile and seam pressure. Beautiful seam an agent discharging need to function in the mouth, with the size of the feeding mouth tilt will have an effect on the capacity, so the cutting of material's mouth is very important. Generally along the top rubber mouth with a knife cut into a 45 degree Angle, the width of the feeding mouth width slightly smaller than brick, uniform flow, to ensure product quality.