Why does the blistering phenomenon occur during the beauty joint construction? -Beautiful seam agent factory

When making beautiful sewing, you will encounter many problems. Foaming during the beautiful sewing is one of them. The editor of the beautiful sewing agent factory received a call from a beautiful sewing master and gave feedback to Mei There are bubbles bulging out of the crevices. I consulted a lot of professional beautifiers, and finally summarized the possible causes of blistering, for your reference: 1. The grassroots is not properly treated, and the tile gaps have moisture before construction. Keep the gaps dry before construction, otherwise it will cause beautiful gaps. Discoloration of the agent. At the same time, as the water vapor evaporates, it will cause the seam to bubble. 2. There is dust in the gaps of the tiles. When the gaps are not cleaned, you must use a vacuum cleaner to clean the gaps of the tiles to prevent dust pollution, which will cause the surface of the glue to be uneven. 3. The tile gap is too small and the construction speed is fast. When the glue is applied, there is a pause or the glue is applied too quickly. The glue does not enter the gap, but on the surface layer, the gas is in the bottom layer. When the gap is pressed later, the gas inside cannot be discharged, which will cause the glue to bubble. Fourth, the construction thickness of the beauty joint is too thin. If the gel construction is too thin, it will not be enough to compact the internal air, and it will easily cause blistering during sizing. 5. Poor quality of beautiful sewing products. Because the production process is not good enough, the colloid is mixed with a lot of gas during the production process, resulting in blistering during construction. 6. The heating temperature of the beauty joint agent is high, which causes the colloid to foam and the temperature is low in winter. In order to reduce the difficulty of gluing, the method of heating the beauty joint agent is often used to solve the problem. But if the temperature is heated too high, blistering will easily occur. Methods and countermeasures: 1. When you see bubbling, use a scraper or spatula to cut and puncture the bubbles in time to make sure that there are no more bubbles at the bottom, then fill in the beautifying agent, flatten it again, and compact it. Then use a scraper to smooth it. 2. When sewing, don't cut the mouth, try to hit vertically, so that as much material as possible hits the gap. 3. Choose regular, quality-guaranteed beautiful sewing products.
Construction, beautiful seam, blistering